1、自動上料攪拌車在冷車狀態下啟動發動機,需對發動機進行必要的預熱,發動機在正常的工作溫度下,其零件之間的運轉阻力、磨損、工作穩定性等方面是的。所以進行預熱是必要的。
1. It is necessary to preheat the engine when the automatic charging mixer starts the engine in the cold state. Under the normal working temperature of the engine, the running resistance, wear and working stability between the parts are the best. So preheating is necessary.
2、自動上料攪拌車在駕駛車輛的過程中,注意觀察儀表上的有關指示,時常觀察水溫表、機油燈、充電指示燈的提示。攪拌車運輸車發現有不良現象即刻處理。
2. In the process of driving the automatic feeding mixer, pay attention to the relevant instructions on the instrument, and often observe the tips of the water temperature gauge, engine oil lamp and charging indicator light. If the mixer truck is found to be defective, it shall be handled immediately.
3、自動上料攪拌車行駛中盡量讓發動機轉速在轉速表的紅刻度以下區,避免發動機超負荷運行,手動擋的車輛盡可能不要拖擋。
3. During the operation of the automatic feeding mixer, the engine speed should be below the red scale of the tachometer as far as possible, so as to avoid the overload operation of the engine, and the manual gear vehicle should not be stalled as far as possible.
4、自動上料攪拌車定期保養發動機,按時按里程對發動機進行保養,選用合適的發動機機油。保持冷卻液的清潔,使發動機有良好的散熱性。定期對發動機的油路和氣路進行清洗。攪拌車油泵維修保證發動機有暢通的進油、進氣通道。
4. The engine of the automatic feeding mixer shall be maintained regularly, and the engine shall be maintained according to the mileage on time, and the appropriate engine oil shall be selected. Keep the coolant clean so that the engine has good heat dissipation. Clean the oil and gas lines of the engine regularly. The maintenance of the oil pump of the mixer ensures that the engine has smooth oil inlet and air inlet channels.
5、自動上料攪拌車油箱中燃油的加注量盡量保持在剩下1/3時即進行加油,以使油箱中的汽油泵良好地散熱,保證汽油泵有足夠長的壽命。
5. The filling amount of fuel in the tank of the automatic feeding mixer truck should be kept at 1 / 3 of the remaining volume as far as possible, so as to make the gasoline pump in the tank well dissipate heat and ensure the long service life of the gasoline pump.
6、自動上料攪拌車要使用符合規定的燃油。燃油的質量對發動機的燃燒影響很大,劣質的汽油會使燃燒室、噴油器、進氣道及氣門等處產生大量的積炭和積膠,攪拌車減速機油封使發動機出現怠速不穩、加速困難等現象。
6. The automatic feeding mixer should use fuel that meets the requirements. The quality of fuel has a great influence on the combustion of the engine. The inferior gasoline will cause a lot of carbon and glue deposit in the combustion chamber, fuel injector, intake port and valve. The oil seal of the reducer of the mixer makes the engine unstable at idle speed and difficult to accelerate.
7、自動上料攪拌車在安靜的狀態下啟動發動機讓發動機怠速和加速運行,聽發動機的聲音是否正常。攪拌車油泵維修正常發動機運行聲音應該是比較低沉而有規律的,如果出現比較尖銳的聲響,請立即去維修廠進行診斷,以避免故障造成更大的損壞。
7. The automatic feeding mixer starts the engine in a quiet state, let the engine idle and accelerate running, listen to the sound of the engine is normal. The oil pump of the mixer truck is maintained normally, and the engine running sound should be relatively low and regular. If there is a sharp noise, please go to the maintenance plant for diagnosis immediately, so as to avoid greater damage caused by the fault.
I believe that read the automatic concrete mixer truck http://www.akware.net After the introduction, we will have our own understanding of this aspect and solve the problems in the future.