混凝土自動上料攪拌車在使用一段時間后,我們經常會遇到進料口堵塞的情況,今天我們就來教大家遇到進料口堵塞的情況該怎么處理呢?
After using the automatic concrete loading mixer for a period of time, we often encounter the blockage of the feed inlet. Today we will teach you how to deal with the blockage of the feed inlet?
1.每天收工時清洗混凝土貯罐及進出料口周圍自動,自動上料攪拌車的清洗要點保證不粘有水泥及混凝土結塊;
1. Clean the concrete storage tank and around the material inlet and outlet at the end of each day. The cleaning points of the automatic feeding mixer shall ensure that there is no cement and concrete caking;
2.每次裝料前用水沖洗進料口,使進料口在裝料時保持濕潤;
2. Wash the feed port with water before each loading to keep the feed port wet during loading;
3.在裝料的同時向隨車自帶的清洗用水水箱中注滿水;
3. Fill the cleaning water tank with water while loading;
混凝土自動上料攪拌車
Automatic concrete loading mixer
4.裝料后沖洗進料口,洗凈進料口附近殘留的混凝土;
4. After loading, wash the inlet and clean the residual concrete near the inlet;
5.到工地卸料后,沖洗出料槽,然后向混凝土貯罐內加清洗用水30—40 L;在車輛回程時保持混凝土貯罐正向慢速轉動;
5. After unloading at the construction site, wash the discharge tank, and then add 30-40 l of cleaning water to the concrete storage tank; Keep the concrete storage tank rotating forward and slowly when the vehicle returns;
6.下次裝料前切記放掉混凝土貯罐內的污水。
6. Remember to drain the sewage in the concrete storage tank before the next loading.
攪拌車進料口給料量是否合理:正確的方式是物料在吸料口和空氣形成一定的氣物混合比,在氣流的推動下均勻流入上料機。這個時候我們需要將料槍設計帶有補氣功能。如果物料積壓時間過長可能很硬,這個時候需要在料槍上裝一個振蕩器,敲碎結塊的物料。
Whether the feeding amount at the inlet of the mixer is reasonable: the correct way is that the materials form a certain gas-solid mixing ratio between the suction port and the air, and flow evenly into the feeder under the promotion of the air flow. At this time, we need to design the material gun with air replenishment function. If the material backlog is too long, it may be hard. At this time, an oscillator needs to be installed on the material gun to break the caked materials.