全自動攪拌車的檢測步驟和油泥產生的影響是怎樣的？_公司新聞_自動混凝土攪拌機知識_自動混凝土攪拌機_自動混凝土攪拌車廠家

站內搜索

自動混凝土攪拌機知識

公司新聞行業資訊

熱點

小型攪拌機的使用功率是多少？

2020-11-16

全自動攪拌車有哪些新的功能？

2021-11-15

自動混凝土攪拌車的保養要注意哪些地方？

2020-08-07

混凝土攪拌機每次清洗養護都檢查哪些？

2020-07-06

關于山汽

聯系人：劉老師

電話：400-879-1999

公司：山東山汽工程機械（集團）有限公司

地址：山東省萊州市206國道與308省道交叉口東南50米

全自動攪拌車的檢測步驟和油泥產生的影響是怎樣的？

所屬分類：公司新聞發布時間：2022-02-25 來源：http://www.akware.net/ 瀏覽量：0

在引入全自動攪拌車檢測步驟時，讓每個人都知道一些未知的問題或知識，但我們對我們所在的行業仍然相對不熟悉。今天我們將逐漸明白：

When introducing the detection steps of automatic mixer truck, let everyone know some unknown problems or knowledge, but we are still relatively unfamiliar with our industry. Today we will gradually understand:

1.電池維護檢查：檢查電池是否牢固固定。

1. Battery maintenance inspection: check whether the battery is firmly fixed.

2.輪胎檢查：每月應檢查室溫下的輪胎壓力。

2. Tire inspection: check the tire pressure at room temperature every month.

3.離合器主泵水位檢查：離合器液位高低液位表示正常，如果低于標準線，則可能是主泵或泵碗損壞。

3. Water level inspection of clutch main pump: the high and low level of clutch liquid level indicates that it is normal. If it is lower than the standard line, the main pump or pump bowl may be damaged.

4.檢查制動液液位：制動液在高低之間也正常。

4. Check the brake fluid level: the brake fluid is normal between high and low.

5.發動機冷卻液液位檢查：當發動機處于高溫狀態時，不要打開散熱器蓋，否則可能會被飛濺的冷卻液或高溫蒸汽灼傷。發動機冷卻后，檢查冷卻液的液位應在滿和低之間。否則，應加入蒸餾水或純凈水或冷凍液。加水后液體的高度不應超過滿水位。如果發現冷卻液在短時間內迅速降低，則自動混合器檢查步驟應檢查冷卻系統是否有泄漏或者到維修站進行檢查。

5. Engine coolant level inspection: when the engine is at high temperature, do not open the radiator cap, otherwise you may be burned by splashing coolant or high-temperature steam. After the engine is cooled, check that the coolant level should be between full and low. Otherwise, distilled water or purified water or frozen liquid shall be added. The height of the liquid after adding water shall not exceed the full water level. If the coolant is found to decrease rapidly in a short time, the automatic mixer inspection step should check whether the cooling system has leakage or go to the maintenance station for inspection.

全自動攪拌車驅動器介紹

Introduction of automatic mixer driver

驅動器用于驅動混凝土罐的旋轉。它由動力輸出單元，萬向軸，液壓泵，液壓馬達，控制閥，液壓油箱和冷卻裝置組成。對于全自動攪拌車，驅動器仍然非常重要，所以讓我們仔細看看。

The driver is used to drive the rotation of the concrete tank. The utility model is composed of a power take-off unit, a universal shaft, a hydraulic pump, a hydraulic motor, a control valve, a hydraulic oil tank and a cooling device. For the fully automatic mixer, the driver is still very important, so let's take a closer look.

1.通用車削部件是故障部件。應及時填充潤滑脂，并經常檢查磨損情況，并及時修理和更換。車隊應該有一個備用萬向軸組件，以確保在發生故障時幾分鐘內恢復。

1. General turning parts are faulty parts. The lubricating grease shall be filled in time, and the wear shall be checked frequently, and repaired and replaced in time. The fleet should have a spare cardan shaft assembly to ensure recovery within minutes of failure.

2.確保液壓油清潔。全自動攪拌車的工作環境不好，一定要防止臟水泥砂進入液壓系統。應根據手冊的要求定期更換液壓油。一旦檢查發現水或沙子混入液壓油中，立即停止液壓系統并更換液壓油。

2. Ensure that the hydraulic oil is clean. The working environment of the full-automatic mixer is not good, so we must prevent the dirty cement sand from entering the hydraulic system. The hydraulic oil shall be changed regularly according to the requirements of the manual. Once water or sand is mixed into the hydraulic oil, stop the hydraulic system and replace the hydraulic oil immediately.

3.確保液壓油冷卻裝置有用。定期清潔液壓油散熱器，防止散熱器被水泥堵住，檢查散熱器風扇是否正常運轉，防止液壓油溫度超標。只要液壓元件確保液壓油清潔，通常幾乎沒有故障，但制造商具有不同的使用壽命。

3. Ensure that the hydraulic oil cooling device is useful. Clean the hydraulic oil radiator regularly to prevent the radiator from being blocked by cement, and check whether the radiator fan operates normally to prevent the hydraulic oil temperature from exceeding the standard. As long as the hydraulic components ensure that the hydraulic oil is clean, there is usually almost no failure, but the manufacturer has different service life.

一般情況下，如果驅動器由于故障停止工作，混凝土水箱將不能正常旋轉，這將導致車輛中的混凝土報廢，甚整個水箱混凝土將在水箱中冷凝，導致全自動攪拌車報廢。因此，驅動裝置是否可靠是在使用中高度重視的問題。

Generally, if the driver stops working due to failure, the concrete water tank will not rotate normally, which will lead to the scrapping of the concrete in the vehicle, and even the concrete in the whole water tank will condense in the water tank, resulting in the scrapping of the full-automatic mixer. Therefore, whether the driving device is reliable or not is a problem of great importance in use.

以上對于全自動攪拌車的檢查步驟和油泥帶來的影響介紹就是這樣了，希望對你有幫助。

This is the above introduction to the inspection steps of automatic mixer and the impact of oil sludge. I hope it will be helpful to you.

以上就是今天帶給大家的知識，全自動攪拌車專注行業多年，為用戶不斷的提供有價值的內容，更多內容請繼續關注我們：http://www.akware.net

The above is the knowledge brought to you today. The full-automatic mixer has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.akware.net

上一頁：全自動攪拌車是怎么自動上料的？下一頁：全自動攪拌車的減速機漏油如何維修要領

熱門產品 / HOT PRODUCT